mit series
Snap-Acting Air relays

The Mite Series of pneumatic relays offer precise control of air or gas service. Their snap-acting design automatically trips on ether an increasing or decreasing signal

Allow 2-3 weeks for shipment  Click Here for Pressure Gauges

!
mite-70

Mite 70

Snap-acting control relay with manual reset

Set to trip on either an increasing or decreasing control signal, the Mite 70 will vent one port to atmosphere while it locks up the pressure in a second line. The tripped position is then held indefinitely until the control signal is restored and a manual reset button is pushed. The trip point is adjustable from 1 to 100 psi with a simple screw stem. The Mite 70 can also be tripped on demand from a separate remote signal. Use the Mite 70 to open safety valves in emergency situations, trigger an alarm while locking up a valve or actuate diaphragm motor valves, air cylinders or other pneumatic actuators.

 
:   lbs
ca_mite71

Super Mite 71L/71H

High or low pressure pneumatic selecting relay

The Super Mite 71 will automatically select the higher or lower of two pneumatic inputs and pass it downstream while blocking the other. Capable of almost instantaneous selection, the Super Mite 71 can separate pressure differentials as low as a tenth of a psi. Although ordered as either high or low pass, the Super Mite 71 can easily be converted in the field from one to the other. The Super Mite 71 can be relied on to open or close valves when a signal pressure drops or rises past a determined value. They can also be used to prevent a valve from opening or closing beyond a critical point. Equal to Moore Products 58S and 58SH High or 612 Low selection relays 

:   lbs
ca_mite74

MITE 73 or 74

Snap-acting control relay with integral 3-way valve

The Mite 74 combines the Mite 70 control relay with a precision 2-way or 3-way valve in a single compact package. Either an increasing, decreasing or remote signal can be used to channel air as needed. The Mite 74 can also be used in combination with either of the Super Mite 71’s so that it will trip when either of two signals drops or rises beyond a set pressure. Once tripped, the Mite 74 will hold its settings until the proper control signal is reestablished and the reset button is pushed.

:   lbs

MITE 85

Snap-acting 3-way valve with two trip points

The Mite 85 allows you to establish two adjustable trip points that control flow through a 3-way valve. An increasing signal that exceeds the high trip point will open “I” port to “H”. A decreasing signal pressure that drops below the low trip point will vent port “H”. This switching action is reversible and repeatable without having to manually reset. Use the Mite 85 to passively switch to a secondary controller in case the primary system fails.

 
 
:   lbs